How to match code with transmitter:
1. Put the transmitter and the receiver close to each other within 1 meters.
2. Turn on the transmitter, then power on the R12DS.
3. Connect CH3 of R12DS to ESC.
4.
There is a black button on the R12DS, use a thin stick press the button
twice in two seconds, receiver light starts blinking, after about
blinking 8 times, match code success and receiver signal LED always on!
Specification:
1) Channels: 12 channels:output12channels signal, supportS-BUS and PWM signaloutputsynchronously.
2) Working voltage: 4.8-10V
3) Working current: 38-45mA(input voltage: 5V)
4) Size: 50*31.5*14.5 MM
5) Weight: 14g
6)
Receiver integrate telemetry sensor including signal strength and
voltage. Support extended engine voltage telemetry module PRM-01 and
module PRM-02 can feedback GPS info, Speed, voltage etc. on
AT9/AT9S/AT10/AT10II display when work with flight controller APM or
PIX.
7) 4096 section precision, 0.25us per section, servo anti-shake rudder.
8)
Control distance: about 4 kilometers air(Maximum range tested in
unobstructed areas free of interference and may vary depending on local
regulations).
Installment of receiver antenna:
1. The antenna must be kept as straight as possible. Otherwise it will reduce the effective range.
2.
Large model aircraft may has some metal part interfering signal; in
this case the antennas should be placedat both sides of the model. Then
the best RF signal condition is obtained at any flying attitude.
3.
The antennas must be keptaway fromconductive materials,such as metal
and carbon. at least a half inch. The coaxial part of the antennas does
not need to follow these guidelines, but do not bend it in a small
radius. 4. Keep the antennas away from the motor, ESC, and other noise
sources as far as possible.
5. Press and hold the Easy Link (ID SET) one second, then the receiver starts work.
6. After all of the above steps were finished, the LED indicator will turn and keep in red.
7. The receiver can be packed by sponge or foam for shockproof when it is installed to the model.
After
all of the above steps were finished, turn off the transmitter and then
power it on, now the program functions to assure it under control of
transmitter with a right connection.
No related record found