Happymodel 2.4g ExpressLRS ELRS Micro TX module ES24TX Transmitter module 24TX80 Antenna for DIY RC Drone

Copy and share this link on social network or send it to your friends

Copy

Happymodel 2.4g ExpressLRS ELRS Micro TX module ES24TX Transmitter module 24TX80 Antenna for DIY RC Drone Item NO.: F43539-D4

Write a Review
US$ 25.64 (5% Off)
US$ 26.99 Save US$ 1.35
Quantity:
Shipping Cost:
Estimate Shipping Cost

Product Name Happymodel 2.4g ExpressLRS ELRS Micro TX module ES24TX Transmitter module 24TX80 Antenna for DIY RC Drone
Item NO. F43539-D4
Weight 0.02 kg = 0.0441 lb = 0.7055 oz
Category DIY RC Drone Accessories > Receiver
Brand Happymodel
Creation Time 2021-04-14

Happymodel 2.4g ExpressLRS ELRS Micro TX module ES24TX Transmitter module 24TX80 Antenna for DIY RC Drone


This Micro TX is designed by Happymodel and based on the open source- ExpressLRS which is a very popular low latency and high re-flashed rate RF module for RC Airplane and FPV Racing. Its main hardware architecture is ESP32, ESP8285 and SX1280 RF chip. The ES24TX module is a complete solution which is already pre-load the Expresslrs firmware and it’s plug and play.

Specifications:
Regulatory Domain: ISM2400
MCU:ESP32(main),ESP8285(aux,as espbackpack)
RF chip:SX1280IMLTRT
JR standard 5pin socket
Frequency Range: 2400 MHz to 2500 MHz
Maximum receive refresh rate: 500Hz
Minimum receiver refresh rate: 25Hz
RF Output Power: 10dBm~24dBm
Power supply voltage: 5v~10v
Weight: 9.5gram(without antenna)
Dimension: 55.5mm*39.5mm*8mm
Antenna gain:1.87dBi

Package include: 
EX24TX *1
24TX80 antenna *1
3D Printed mounting box *1
Antenna adapter cable *1

Since the official ExpressLRS perfect program has not been released yet, our pre-installed program is a beta version, because there are too many types of beta version programs , so you can download the out of factory firmware from our website. There are two kinds out of factory firmware of ES24TX, one is to match Happymodel PP RX receiver (program version identification code 6cb8152d) and the other is to match Happymodel EP1 and EP2 RX receivers (program version identification code aec8ad82), The default factory firmware is aec8ad82 which matching EP1 and EP2 RX
You can copy the firmware to the SD card, and then directly update the firmware of the ES24TX on the RC remote control.

No related record found

You May Also Like