Feichao High power 4CH Remote Control Transmitter Receiver 27MHZ Manual DIY RC Car Model Toy Accessories Item NO.: F28472

Feichao High power 4CH Remote Control Transmitter Receiver 27MHZ Manual DIY RC Car Model Toy Accessories

This set includes one remote control, one receiving board and two antennas. It can control two small motor rotations at the same time. It is easy to use and cost-effective. It is suitable for all kinds of DIY enthusiasts to make remote control model toys.

[Current]: 0-4A
[Remote frequency]: 27MHZ
[B F line]: Connect the forward and reverse motors
[R L line]: Connected to the steering motor
[VCC line]: positive power supply
[GND line]: negative power supply
[ANT white line]: wire antenna
[wire length]: about 200 mm

[Remote control voltage]: 3V (2 AA batteries)

[Receiving board voltage]: DC4.5--7.2V (6V recommended)

[Adaptation motor]: It can control the motor with the store voltage ≤6V

【Wiring】:

VCC red line is connected to the positive pole of the power supply; GND black line is connected to the negative pole of the power supply;

The two lines (blue line and white line) at the F and B characters are connected to the motor that needs to advance and retreat;

Two wires (green line and yellow line) at the R and L characters are connected to the motor that needs to be turned;

The white line with the ring metal piece is the antenna.

[Remote control size]: about 100*100*36mm

[Receiver board size]: PCB board size 40*52mm

[Tips]: When using, do not cover the 8 black square triodes on the receiving board with cover. When outputting a large current, it needs to be exposed to the air to dissipate heat. If you can make a metal block radiator to install it yourself, then it is better. Oh!

[set weight]: about 105 grams