NGFF to SATA3 Adapter Card M2 KEY B-M SSD Solid State Drive to 6G Interface Conversion Card Adapter
Weight: 80g
Function: Product Model:
ENCNF2S-N01
Product interface:
SATA 22PIN
Product interface:
M.2 KEY-B
Product rate:
SATA3.0 6Gbps does not support NVME and PCIE protocol SSD
Read and write instructions:
blue LED
Operating temperature:
-30- 70°C
support system:
WINXP/WIN7/WIN8/WIN10/WIN11/LINUX/MA
Features:
Transfer the M.2 hard disk defined by KEY-B-M SATA of the motherboard to the SATA 22PIN interface. This adapter board only connects the signal from the M.2 hard disk to the SATA 22PIN connector, so the adapter card does not need a driver. If you can't recognize the hard disk, please check whether it is an M.2 interface, the card is basically not faulty, please know.
Supports all SATA standard M2.SSD, does not support the new NVME M2.SSD Important thing to say 3 times, does not support PCI-E M2 SSD
product description:
1: This card is suitable for 4 different lengths of SSD hard drives, suitable for different lengths of M2 (NGFF) SSD hard drives such as 3cm, 4.2cm, 6cm, and 8cm. Using ceramic filter capacitors, high-power LDO voltage regulator control chip, stable performance! Our products are tested before shipment.
The riser card only changes the interface form of the solid state drive, and does not change any performance of your hard drive. What are the parameters of your original hard drive, with the riser card, the output interface performance will not change.
Hardware Requirements:
A motherboard with SATA interface, a notebook or a riser card
One M2 KEY B-M SSD
NVME disks are not supported, please be aware
No related record found