Home>RC Toy Drone>QWINOUT F4-V2 178mm Quadcopter DIY FPV Racing Drone Kit F4 2-6S AIO Flight Controller 35A Brushless Motor Support Card Video Recording
QWINOUT F4-V2 178mm Quadcopter DIY FPV Racing Drone Kit F4 2-6S AIO Flight Controller 35A Brushless Motor Support Card Video Recording

QWINOUT F4-V2 178mm Quadcopter DIY FPV Racing Drone Kit F4 2-6S AIO Flight Controller 35A Brushless Motor Support Card Video Recording Item NO.: F43623-L F43623-M N O P Q R S T U

Write a Review
US$ 144.99
Version
PNP with 3S Battery with FLYSKY RX with FRSKY RX with FLYSKY Radio with FLYSKY Radio n Battery RTF FLYSKY with FRSKY RX n Battery with T-lite Radio n Battery RTF T-lite
Quantity

Copy and share this link on social network or send it to your friends

Copy
Product Name QWINOUT F4-V2 178mm Quadcopter DIY FPV Racing Drone Kit F4 2-6S AIO Flight Controller 35A Brushless Motor Support Card Video Recording
Item NO. F43623-L F43623-M N O P Q R S T U
Weight 0.44 kg = 0.9700 lb = 15.5205 oz
Category RC Toy Drone
Brand QWINOUT
Creation Time 2021-06-02

QWINOUT F4-V2 178mm Quadcopter DIY FPV Racing Drone Kit F4 2-6S AIO Flight Controller 35A Brushless Motor Support Card Video Recording


Note: They are 10 versions, pls choose the corresponding version according to the picture.


Paddle

Product Name: 4032
Propeller pitch: 3.2 inch wheels
Hub size: 5mm
Weight: 3.09g
Material: PC
Center thickness: 6.5 mm
Propeller diameter: 102.2mm


Flight control and ESC integration

Product name: Integrated 25A 4 in 1 ESC F4 OSD flight controller
Size: 32.5x32.5mm
Mounting hole: 25.5x25.5mm
Weight: 7.3 grams
CPU: STM32F411CEU6 (100MHZ)
Firmware: Betaflight JHEF411
Integrated OSD Betaflight (AT7456E)
BEC output (two): 9V / 2A, 5V2.5A
Receiver: SBUS, IBUS, DSM2, DSMX, TBS (UART2)
Black box: 8MB
Built-in current sensor
Support WS2812 LED
Input voltage: 2-6S Lipo
ESC current: 35A
Firmware: BLHELI_S GH-30.HEX
Support PWM, Oneshot42, Oneshot125, Multishot, Dshot150 and Dshot300, Dshot600


Image Transmission

Output power: 25~200mw
Switchable frequency: 40CH
Input voltage: 3.3V 5.5V
Current consumption: 250mA~510mA (type)
Antenna: RG178 antenna
U.FL interface
Frequency: 5.8GHz 5 band 40 channels
Weight: 3g (without antenna)
Video output size: VGA (640x480)
Video output format: NTSC
Recording video size: 1280x720 @ 25FPS
TF card support: up to 32G


Motor

Specification: 1806
KV: 2500
Support battery: 3-4S
Weight: 21.1g


Camera

Sensor: CMOS 1/3
Lens: 1.8mm
Video format: PAL/NTSC switchable
Resolution: 1200TVL
Input voltage: DC4.5V-25V
Weight: 4.5g
Size: 19x18.7mm(W*L)
White balance: automatic
WDR: 90db


Receiver version:

FRSKY version, FLYSKY version, without receiving version


Note:

1 Do not charge the battery when you are away from home, do not charge the battery immediately after flying, and do not over-discharge the battery (over-discharge may cause the battery to fail to charge and become useless). The battery cannot be powered off in time after it is fully charged. Charge for a long time.
2. Do not modify any parameters and wiring without knowing the flight control and remote control.
3. Turn on the remote control before powering on the aircraft, unplug the power switch after the flight, and then close the remote control to prevent accidents.
4. This product is not a toy and is not suitable for children under 14 years of age.
5. If you are a beginner, it is recommended to be assisted by an experienced adult
6. Novices should pay attention not to take the airplane by hand when the airplane is turning or let children take it to prevent it from being scratched
7. Please turn off the start switch in time when the aircraft falls from a high altitude or hits other objects during flight, otherwise it may cause damage to the flight control motor, etc. Check whether the aircraft is damaged or the screws are loosened, etc. before taking off again when everything is normal.


No related record found