|
| Quantity | 0-3 | 4-50 | 51-100 |
| Discount | 0% OFF | 5% OFF | 10% OFF |
| Price | US$ 9.30 | US$ 8.84 | US$ 8.37 |
Copy and share this link on social network or send it to your friends
Copy| Product Name | N Female 1 to 2 Way Power Splitter 380-2500MHz Signal Booster Divider N-Female Connector 50ohm |
| Item NO. | F47248 |
| Weight | 0.17 kg = 0.3748 lb = 5.9966 oz |
| Category | Consumer Electronics |
| Creation Time | 2022-06-20 |
Working frequency: 380-2500mhz
Impedance: 50 ohms
Dimensions: 89x84x29mm
Maximum power: 50W
Interface type: N female
Standing wave: 1:1.3
Weight: 0.148kg
Installation instructions:
1. The feeder (recommended to follow 50-7, 50-5, 75-7) is connected to the N female head of the host or the antenna through the project-specific N male head (N-K head + F head transfer is not recommended, so the maintenance of the transfer Large workload and signal attenuation; 8m≤feeder length≤50M, fixed on the roof or balcony after installation (note: it is best to choose the roof, because the received signal quality is good and the direction is easy to adjust).
2. Then check whether the signal has been led indoors (the mobile phone is close to the copper cable, check whether the signal is full), if there is no signal indoors, please change the fixed position of the outdoor antenna and choose a better place. The next step is to connect the host outdoor port: OUTDOOR.
3. Indoor: Connect to the host's: INDOOR with a feeder, and then connect to the indoor transmitting antenna. (The coverage of an antenna is 80 square meters, if you have more than 100 square meters, you need to connect a distributor or a dedicated power divider).
4. After connecting to the indoor antenna, place the indoor antenna in the signal dead zone, and then plug in the power supply to test.
Related configuration:
The mobile phone signal amplifier cannot be used alone, a complete system also needs: outdoor antenna (Yagi directional antenna), indoor antenna, and connecting feeder! (Please purchase the feeder according to the actual length required)
Here is a recommended reference for you:
1. Determine whether you need GSM or CDMA.
2. Determine the host model according to the applicable area.
3. Determine the length of outdoor and indoor antennas and feeders.
Outdoor antenna: A directional Yagi antenna is recommended.
Indoor antenna: Indoor wall-mounted antenna or indoor ceiling antenna is recommended.
other:
1. Working conditions: Ensure that there is a signal source that can communicate normally near the area to be enhanced.
2. Model selection: Choose different models according to the area, the strength of the outdoor signal, the indoor environment and the size of the area.
3. Protection circuit: The host can work stably in various environments without damaging the machine itself.
4. Quality control: each machine is tested before delivery → aging for more than 48 hours → pass the test → delivery.
5. Heat dissipation performance: the host aluminum alloy heat dissipation shell.
Email：yxy@xt-xinte.com
Wechat:15012645226
No related record found