XT-XINTE JMS585 Chip 5 ports SATA 3.0 to PCIe Expansion Card 4X Gen 3 PCI Express SATA Adapter SATA 3 Converter with Heat Sink for HDD
Product specifications:
Compliant with Serial ATA 3.0 specification, backward compatible with SATA2.0 SATA1.0
Compliant with PCI-Express v2.0 specification and backward compatible with PCI-Express v1.0.
Supports communication speeds of 6.0 Gbps, 3.0 Gbps and 1.5 Gbps
Support Gen 1i, Gen 1x, Gen 2i, Gen 2m, Gen 2x, and Gen 3i.
Support 5 SATA full speed
Support AHCI1.0 mode and IDE mode
Support for native command queue (NCQ)
Support FIS based on port multiplier switch or command switching.
Support hot swap and hot swap.
Compatible with SATA6G, 3G and 1.5G hard drives
Bus interface: PCI-Express x2 GEN3 slot (actually PCI-E X2 signal, interface is X4)
Expansion interface: 5 SATA3.0 interfaces
System Requirements: One PCI Express X4 slot is available, supporting both PCI-E X8 X16
Operating system: Windows10/8/7 (32/64 bit) / Vista (32/64 bit) / XP/2003/2008/linux
The PCIE to SATA3.0 riser card is used as follows:
First, the system disk and PCIE to SATA3.0 riser card connection conditions and solutions:
1. The SATA interface mode of PCIE to SATA3.0 is AHCI mode, if you want to plug in the system disk on our card. The premise is that your system disk must be installed in AHCI mode when installing the system on the motherboard. Otherwise, the system cannot be booted through our card adapter card.
2. If it is determined that the SATA interface installation system of the system disk inserted in the motherboard is AHCI mode, then you can directly insert the hard disk into our card, and then enter the motherboard BIOS to set the system disk as the first boot.
3, the above two conditions are available, if it still can not start, or repeatedly restart. It may be that the hard disk interface of the motherboard conflicts with our adapter card. The solution is to enter the motherboard BIOS, set the hard disk interface option of the motherboard to Disabled, and save the restart to start the system.
Second, the common disk and PCIE to SATA3.0 connection conditions and solutions:
1. When the system disk is inserted on the motherboard, the ordinary disk is inserted in the PCIE to SATA3.0 card, then only the adapter card information and the normal disk model need to be detected at startup.
2. If condition 1 is established, or the system cannot be started, then you must enter the BIOS of the motherboard and set the system disk to the first boot.
Third, the system disk and the ordinary disk and PCIE to SATA3.0 connection and solution:
1. Premise, if the system disk with the original motherboard installed system is AHCI mode test, can use the following methods to achieve, if it is IDE mode installed system, then you can only reinstall the system through PCIE to SATA3.0 .
2, 1 condition is established, you can not start to enter the motherboard BIOS, set the system disk to the first boot.
3. Condition 1.2 is established, if it still cannot be started. May be the integrated SATA interface conflict, please enter the motherboard BIOS to set SATA to Disabled.
Packaging accessories:
SATA3.0 expansion card*1
No related record found