JMT Tarot FASST Mode Receiver TL150F2 Compatible 2.4GHz FUTABA FASST Air System SBUS RX DIY RC FPV Racing Drone

1.INTRODUCTION
1.1 Compatibility:FASST 2.4GHz Air Systems(7CH Mode/Multi Mode):6EX,7C,TM-7,TM-8 T8FG,T10C,TM-10,T10CG,T12Z,T12FG,TM-14,T14MZ etc.
1.2 Specifications:
Working temperature range:-10~+80°
Operating voltage range:3.5~8.4V
Output channel:16CH
Dimension:29x19x7.5mm
Weight:4.2g
Receiving mode:FASST
Output signal:RSSL & S.BUS(1CH~16CH)
Servo frame rate:14ms(FS-normal speed mode)
                 7ms(HS-high speed mode)
1.3 Features:
1)Compatible with FASST 2.4GHz Air Systems(7CH Mode/Multi Mode);
2)With RSSL output;
3)Adopt american-made IC,improve sensitivity and stability;
4)Compatible with Futaba S.BUS servos;
5)Ideal for the FPV racing drones competition.
2.SETUP
2.1 Bind procedure:
Turn on the transmitter,connect the battery to the receiver while pressing receiver is F/S button.After the red LED is off and green LED is solid the binding process is completed and the receiver is operating normally.
2.2 LED status:

3.HOW TO SWITCH BETWEEN HS Mode with FS Mode  
HS:High Speed 
FS:Fast Speed
Turn the transmitter off,connect the battery to the receiver,press the  F/S button of receiver for 6 seconds and then release.the red LED will flash fast in HS Mode and slow in FS Mode.Repeat this to alternate modes.
WARNING:HS mode is only applied for high-speed digital servos.Other servos should select FS mode otherwise servos will get hot or even burn out.
Product Specification :
FASST Mode  SBUS  receiver *1    
Double SBUS plug connection cable *1  
Single  SBUS plug connection cable *1 
Manual *1