JMT ​2S 7.4V 2000MAH 8C Transmitter RC Lipo Battery AKKU 66*36*17mm for Jumper T16 Plus Open Source Multi-protocol Remote Controller

JMT ​2S 7.4V 2000MAH 8C Transmitter RC Lipo Battery AKKU 66*36*17mm for Jumper T16 Plus Open Source Multi-protocol Remote Controller Item NO: F31553

US$ 3.87 (15% Off)
US$ 4.55 Save US$ 0.68
Quantity:
Shipping Cost:
Estimate Shipping Cost
Product Name JMT ​2S 7.4V 2000MAH 8C Transmitter RC Lipo Battery AKKU 66*36*17mm for Jumper T16 Plus Open Source Multi-protocol Remote Controller
Item NO F31553
Weight 0.1560 kg = 0.3439 lb = 5.5027 oz
Category DIY RC Drone Kit / RC Drone Accessories > Battery and Charger
Brand JMT
Creation time 2019-09-09

JMT 2S 7.4V 2000MAH 8C Transmitter RC Lipo Battery AKKU 66*36*17mm for Jumper T16 Plus Open Source Multi-protocol Remote Controller

Description:
Battery parameter:  7.4V 2000mah 8C
Capacity: 2000mah
Size: 66*36*17mm
Continuous Discharge Rate: 8C
Weight: about 120g
Cables: 1x Remote Controller Plug, 2x Charging Plug (Support 2 kinds of Balance Charger for Charging Like B6AC and B3)
Compatibel with Jumper T16 / T16 Plus Open Source Multi-protocol Radio and Other kinds of Remote Controller which with similar Battery Seat and Parameter required. 
Note: due to the difference between the measurement, the battery dimension and weight may have little error.
 
Caution:
Don't over-charge, or over-discharge batteries.
Don't put it beside the high temperature condition.
Don't throw it into fire.
Don't throw it into water.

 
Package Included:
1 x 7.4V 2000mah 8C Transmitter Lipo Battery


To avoide improper usage of the item,please read the followings carefully:
1.Before using it,please full charge it with specific lipo balance charger;
2.Charge lithium batteries at no more than 4.20V per cell. As for battery pack in series, please choose balance charging or charge each cell respectively
3.Charing temperature must range in 15-35celcius , Reverse charging is prohibited.
4.The voltage difference between any two cells should be in 0.03V,or charge is advised to balance the voltages before usage.
5.Please make sure the cut-off voltage is not lower than 3.0V, and we highly recommend not lower than 3.3V
6.Never discharge batteries with current over the designed maximum continuous discharging current which was regulated in relevant specifications, or the performance may be deteriorated and cycle life be shortened, causing overheating and even swelling, breakage, internal short-circuit, etc
7.If the surface temperature exceeds 65 celcius while functioning, the battery should be suspended using until it cools down to ambient temperature naturally. Higher temperature may result in battery swelling and performance
8.Do regularly charge &discharge for maintenance (about 1-3 times every 3 months),batteries must be stored at about 3.8V/cell
9.Do store batteries at a place with low-humidity and free from corrosive gas within the temperature ranged from -20 celcius to +40 celcius.
10.Under any circumstances disassembly of batteries is prohibited.



No related record found

You May Also Like