Copy and share this link on social network or send it to your friends
Copy| Product Name | HappyModel X12 AIO 5in1 1-2S Flight Controller Built-in BLHELIS 12A ESC OPENVTX 400mW For FPV Tinywhoop Toothpick Drone |
| Item NO. | F47093 F47094 F47095 F47096 F47093-D2 |
| Weight | 0.03 kg = 0.0661 lb = 1.0582 oz |
| Category | DIY RC Drone Accessories > Flight Control |
| Brand | Happymodel |
| Creation Time | 2022-05-07 |
Flight controller
X12 ELRS V2.0 flight controller built-in ELRS 2.4G receiver Target: CRAZYBEEF4SX1280
X12 Frsky V1.0 flight controller built-in FRSKY 2.4G receiver Target: CRAZYBEEF4FR
X12 PNP V1.0 flight controller without onboard receiver Target CRAZYBEEF4DX
X12 LITE V1.0 flight controller built-in ELRS 2.4G receiver Target:CRAZYBEEF4SX1280
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Built-in Betaflight OSD(SPI Control)
Built-in current meter sensor , current meter scale 470
Onboard 4in1 ESC
Power supply: 1-2S LiPo/LiPo HV
Current: 12A continuous peak 15A (3 seconds)
Support Bluejay firmware
When use Blujay firmware with 48khz, should set startup power to 1100/1200
Onboard SPI ExpressLRS 2.4GHz Receiver
Packet Rate option: 50Hz/150Hz/250Hz/500Hz
ExpressLRS Firmware version: V2.0
Antenna : SMD antenna
Receiver protocol: SPI ExpressLRS
Compatible with ExpressLRS V2.0 TX Module
Couldn't flash separately ExpressLRS firmware
Onboard Frsky SPI D8/D16 receiver Version
SPI BUS receiver
CC2500 RF
Support Frsky D8/ D16 , Redpine , SFHSS
Onboard 5.8g OPENVTX
Firmware version: OPENVTX
Smartaudio v2.1
PIT Mode support
RCE Mode support
Channels:48ch
Transmitting Power: 0/RCE/25mw/100mw/400mw
Power supply: DC 5V
Current (5v): <650ma (400mw)
Antenna connector: U.FL
HappyModel X12 AIO 5in1 1-2S Flight Controller Built-in BLHELIS 12A ESC OPENVTX 400mW for FPV Tinywhoop Toothpick Drone
The world first 5-IN-1 AIO flight controller, OPENVTX(up to 400mw), 12A
Brushless Blheli_S ESC and Betaflight OSD coming out recently.
It comes with onboard SPI ELRS receiver
which support ELRS TX module 2.x firmware, and also provide other
receiver option like SPI Frsky receiver which support Frsky D8/D16 ,
REDPINE and SFHSS.
This is an amazing flight controller
for Brushless whoop. You could get unbelievable RX and VTX range by
using this flight controller.
Specifications:
Brand Name: Happymodel
Item Name: X12 AIO 5-IN-1 Flight controller built-in 12A ESC and OPENVTX
Betaflight firmware target:
ELRS Version: CRAZYBEEF4SX1280
FRSKY Version:CRAZYBEEF4FR
PNP Version:CRAZYBEEF4DX
LITE Version:CRAZYBEEF4SX1280
VTX antenna: U.FL
Weight: 5.1g
Size: 30mm*30mm*8mm
Sensor: MPU6000 or ICM20689 or BMI270(SPI connection)
Mount hole size: 25.5mm*25.5mm
Power supply: 1-2S battery input (DC 2.9V-8.7V)
Built-in 12A(each) Blheli_S 4in1 ESC
Built-in 5.8G OpenVTX 0mw~400mw
Built-in ExpressLRS 2.4G,Frsky D8/D16
Built-in voltage meter sensor , voltage meter scale 110
Support BLHeliSuite programmable
Factory firmware: Z_H_30_REV16_7.HEX
Default protocol: DSHOT300
RF Frequency: 2.4GHz
Telemetry output Power: <12dBm
Compatible Non EU transmitter D8 model Channels: 8ch
No ground interference ( Transmitter and receiver 1 m from the ground): 200meterFailsafe support
SKYPE: +8615012643826
Email:yxy@xt-xinte.com
No related record found