GEPRC GEP-FX4 GEP-FX45 GEP-FX6 flyFish FPV Racing Frame with 3D Printed TPU Hood Item NO.: F36785-F36811

GEPRC GEP-FX4 GEP-FX45 GEP-FX6 flyFish FPV Racing Frame with 3D Printed TPU Hood

Features:
1. 3K high-strength carbon plate to ensure strong frame
2. In order to reduce wind resistance, a streamlined 3D print is used, which looks like a fish
3. 5 inch wheelbase 195mm, 4 inch wheelbase 175mm, 6 inch wheelbase 230mm
4. The frame is X-shaped with 90 degrees between each arm (square X). This has the advantage of being flexible in every direction
5. Strong, beautiful structure and light weight (72g, including all fixings)
6. The position of the motor compartment is widened. Like a fish tail, it is not easy to hit the motor by a collision, and the strength of the motor is also increased.
7. Adjustable lens, 35-60 degrees
8. Comes with a power distribution board, integrated XT60, with BEC (5 / 12v output)
 
Parameter:
Model: GEP-FX5 flyFish
Weight: 72g (include Aluminum parts)
Wheelbase: 195MM 5inch props
Total Measurement: 188 * 185mm
Integrated anti-thickness: 4mm
 
Recommended configuration(not included):
Flight control: F3 / Naze32 / CC3D
Motor: 2204/2205/2206/2305
ESC: 20A-30A
Paddle: 5inch
Battery: 3S 1300mAh ~ 4S 1300mAh

Introduction:

Beautiful, light, racing, and extremely low wind resistance. This rack that looks like a "fish" was born. Our team called him "flyFish". The wheelbase of the frame is 195mm, and a 4mm thick 3K carbon plate can be used to fit a 5-inch propeller. The motor base is a very good design. It looks like a fishtail. It can protect the motor and strengthen the strength of the motor base. The fuselage head uses 3D printing technology, TPU material, this material is a good material rare for the fuselage, flexible material, impact resistance. The lens adjustment angle is 35-60 degrees, which is suitable for flying. Of course, we will also consider launching fixed-angle 3D prints in the future, such as 35 degrees, 45 degrees, 50 degrees, and so on. This advantage is also obvious, which can better reduce wind resistance. We chose to integrate the PDB. The XT60 interface is only shown on the side, eliminating the weight of a cable. At the same time, the PDB integrates 5V BEC, and the space inside is large enough.