FEICHAO 2.4G Remote Controller kit Control Board Launcher Transmitter with Receiver Module for DIY Foam Airplane Model

1. Principle of use:

(1) This remote control kit can be used to make hand-thrown foam airplanes. First, you must have a foam body, which can be made by yourself. Then it needs to be equipped with 2 main thrust motors and 1 tail steering tail motor.

(2) Two main thrust motors are connected in parallel and installed on the wings respectively. The center of gravity of the aircraft should be balanced one-third of the front of the wings. Pay attention to the wind blades facing backwards and ensure that the blowing wind faces backwards.

(3) A small fan blade is installed at the tail steering motor of the aircraft, which is installed in the same way as a helicopter tail blade, and the blade is blown to the side.

(4) Connect this remote control kit according to the wiring instructions. After connecting, turn on the switch, the thrust main motor will rotate normally, and the tail motor will stop by default. By adjusting the black slider on the remote control board, you can control the speed of the thrust main motor and adjust the flight speed of the aircraft. Through the two black touch switches on the remote control board, you can control the forward and reverse rotation of the steering tail motor to realize the aircraft steering.

(5) The battery is too large and heavy, and it is not easy to take off. In addition, the motor and the receiving board will heat up after working for a long time.

At present, aircraft in the industry generally fly continuously for 10 to 20 minutes, so as not to burn the motor or receiving board. When the battery is dead, it's just a break to charge.

2. Receiving board wiring mode:

(1) M+.M- interface: connect two thrust main motors in parallel (support 716/720/820/8520/1020 coreless motors, 1.25 interface terminals, support thrust main motor throttle proportional speed control, the main motor should not be too small, When the low-throttle output is suitable for a small motor for a long time, the small motor is not suitable for the high-throttle output, and it will get hot and hot for a long time. The diameter of the propeller supported by the main motor can be as large as 76 mm.)

(2) M2+.M2-interface: connect to the tail steering motor (support 410/610/612/614/615/716 coreless motor, you can also choose airplane electromagnetic rudder.)

(3) How to turn on the receiving board: press and hold the black button of the receiving board for 3 seconds, and the red light will turn on; press and hold for 3 seconds to turn off the power, and the red light will go out;

(4) The power supply mode of the receiving board: select a polymer lithium battery between 3.7V150mah and 7V400mah (rate 20-25C), and the reserved terminal on the receiving board is a PH2.0 connector terminal. (Reminder, the size and weight of the battery affect the take-off of the aircraft, and the motor and the receiving board will heat up after continuous long-term operation.)

(5) Receiving board charging method: The 2.5mm round hole below the button is the charging port. The red light is on during charging, and the red light is off when fully charged. The aircraft remote control board can directly charge the receiving board. A charging cable is required. One end of the charging cable is a USB male connector, which is inserted into the USB socket of the remote control board. The other end of the charging cable is a dc2.5mm diameter plug, which is inserted into the receiving board. Charging hole.

3. Wiring mode of remote control board:

(1) Wiring mode: B+ connects to the positive pole of the power supply, B- connects to the negative pole, powered by 4 AA batteries (6V)

(2) Switch mode: turn on the toggle switch, the yellow light flashes

(3) Two parallel thrust main motors speed regulation mode: the black slide on the remote control board can control the thrust main motor speed

(4) Steering tail motor forward and reverse operation: 2 black light touch switches, control the steering tail motor forward and reverse

Package Include:

1x Transmitter Board

1x Receiver Board