BETAFPV F411 F4 2-4S AIO Brushless Flight Controller 12A V2 (BLHeli_S) Built in BetaFlight OSD for Toothpick Mini Drone Quad

PACKAGE

1 * F4 2-4S brushless flight controller with XT30 Plug

4 * M1.2x4mm screws

4 * M1.4x5mm screws

4 * Anti-vibration rubber dampers

SPECIFICATIONS OF FC

CPU: STM32F411CEU6 (100MHZ )

Six-Axis: MPU6000 (SPI connection)

Size: 26mm x 26mm, whoop mounting pattern

Firmware version: BETAFPVF411 (BEFH)

OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode)

Receiver: Support Frsky XM/XM+ Receiver/ Futaba Receiver/ Flysky Receiver/ TBS Crossfire Receiver. Add Frsky R9M Receiver and BETAFPV Micro DSMX Receiver (Don't support DSMX RX with 3.3V solder pad ) since V1.2.

Support programmable LED like WS2812 etc

Built-in current sensor

Weight: 5.07g

F4 AIO FC 12A V2 is upgraded in these 2 spark points.

3 full UARTs (UART1, UART2 and UART6) are available. Pilots could use one UART for DJI digital FPV unit or Caddx Vista digital FPV unit and the other UART for external receiver like TBS Crossfire.

Also this board is light only 5.07g and suitable for brushless whoop like 2S Pro 2 Series/ X Series. Integrated with a Betaflight MATEKF411 processor FC, Betaflight OSD and 2-4S 12A ESC which can support 4S battery for fast flying experience. 

DIAGRAM FOR F4 2-4S AIO FC V2

SPECIFICATIONS OF ESC

Support BLheli/BLHELI_S suite Pass-through ready

Support PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600

Input voltage: 2S-4S Lipo

Continue current: 12A

Peak current: 13A

Firmware: BLHELI_S

Processor: SILABS EFM8BB21F16G

Motor Connectors: 1.25mm header pins connector

Factory firmware: G-H-30-16.7

 

HOW TO CONNECT THE EXTERNAL RX TO THE FC

Here is the connection diagram with Frsky XM+ receiver.

Here is the connection diagram with FS-RX2A receiver.

Here is the connection diagram with Futabe-X-BOSS AC900 receiver.

Here is the connection diagram with TBS Crossfire receiver.

Here is the connection diagram with DSMX FullSpeed receiver.

Status LED

There are 3 LEDs on the bottom of the board to indicate the status, including Receiver LED ( Green), FC Status LED ( Blue ) and FC Power LED ( Red ).