iFlight SucceX F7 TwinG FC Flight Controller with SucceX 50A 2-6s BLHeli_32 Dshot1200 4in1 ESC Flytower for FPV Racing Drone Quadcopter DIY Models Item NO.: -F28464

iFlight SucceX F7 TwinG FC Flight Controller with SucceX 50A 2-6s BLHeli_32 Dshot1200 4in1 ESC Flytower for FPV Racing Drone Quadcopter DIY Models

FC Specifications:
MCU：216MHz STM32F722RET6 
Gyro: 2x ICM20689（SPI） 
Baro：NO 
OSD：AT7456E 
Blackbox: Onboard, 32MB
5x Uarts
8x Motor outputs
8-pin 4in1 ESC port
4-pin VTX connector
FC Firmware 

Betaflight/INAV 
Target：EXF722DUAL
Physical 

Mounting hole：30.5*30.5mm，φ4mm with Grommets φ3mm
Size：36*36mm 
Weight：6.2g 

SucceX 50A 2-6S BLHeli_32 Dshot1200 4-in-1 ESC

Features:

8 layers double-sided PCB board;
4oz 1.6mm thick power board(0.9mm copper ratio),better operating load capacity;
32bit FO51K86 MCU, 48mHz maximum clock speed;
TDK MLCC Low ESR ceramic capacitors;
Top grade NTMFS5C430NL MOSFET;
Rational layout, countersunk holes on extended solder pads to ensure PCB layer connection

Specification:

Dimension: 43*39mm
Mounting Holes: 30.5*30.5mm/Φ3mm
Weight:14.4g
Supports 2-6S lipo input
STM32F051 MCU, 48Mhz Runs BLHELI 32.X Firmware
Current sensor: Yes
BEC: No
Supports: DShot DShot150/300/600/1200/MultiShot/ OneShot etc.
Target: iFlight-BL32-4IN1

RECOMMENDATION:
No additional capacitor needed up to 5S!
To encounter back EMF and ensure the longevity of your electronics, min. 220uF Cap 35V for 4-5S, 50V for 6S on your main lead!