iFlight SucceX-D Mini F7 TwinG Stack with F7 TwinG V2.0 Flight Controller /SucceX Mini 55A 2-6S 4-in-1 ESC 600MW VTX for HD FPV Item NO.: F44606-D1 F44606-D2

iFlight SucceX-D Mini F7 TwinG Stack with F7 TwinG V2.0 Flight Controller /SucceX Mini 55A 2-6S 4-in-1 ESC 600MW VTX for HD FPV

PRODUCT DESCRIPTION

The SucceX-D Mini F7 is designed to work seamlessly with DJI’s new HD FPV system. To make things even simpler, the DJI Air unit can just be plugged into the FC with the

included wire harness. In addition, we added the popular and reliable USB Type-C instead of Micro USB and therefore the same standard than your DJI module.

But the real magic of this flight controller lies in its TWIN GYRO configuration.

The TwinG uses two identical gyros oriented side by side with one offset 90 degrees from the other. Betaflight uses GYRO FUSION to blend and average the information from both

gyros to send a much cleaner signal to the PID loop controller! Less noise and fewer oscillations across the throttle band without adding any delay! Betaflight software filters

can be lowered in most cases as well, which brings a significant decrease in delay.

With plenty of processing power and UARTS, this is also the perfect flight controller for long-range GPS builds. And the TwinG configuration makes it the perfect FC for builds like macro quads, cinematic filming rigs and x-class racers that are a bit trickier to tune.

FC // SucceX-D Mini F7

MCU: 216MHz STM32F722

Gyro：2x ICM20689

Blackbox：32MB

Betaflight OSD: YES

BEC: 5V 2.5A / 9V 2.5A

Current sensor scale:  100

Inverter for SBUS input (UART2-RX)

Smartaudio & Tramp VTX protocol supported

Beeper pad : Yes

RSSI input pad: No

UARTs：5

Motor outputs: 4

8 pin 4in1 ESC port (GND, VBAT, M1, M2, M3, M4, CUR, R5)

6 pin DJI Air Unit port (R1, GND, R2, T2, GND, 9V)

BLHeli32 Telemetry：Yes

Input voltage：recommended 2-6S, MAX 6S

Firmware target: IFLIGHT_F722_TWING

Mounting pattern: 20*20mm φ3

Dimensions:   29*29mm

USB type-C

ESC // SucceX Mini 55A

DIMENSION: 31*29.5MM

MOUNTING HOLES: 20*20MM/Φ4MM

WEIGHT: 10.8G

SUPPORTS 2-6S LIPO INPUT

MCU：G071

CONSTANT: 55 AMPS

BURST: 60 AMPS

CURRENT SENSOR: YES

BEC: NO

CURRENT RATE: 100

SUPPORTS: DSHOT DSHOT150/300/600/MULTISHOT/ ONESHOT ETC.

FIRMWARE: BLHELI 32

TARGET:  IFLIGHT-G071-4IN1

Package included:

1pc x SucceX-D F7 Mini TwinG Flight Controller

1pc x SucceX Mini 55A 4in1