Home>DIY RC Drone Accessories>ESC>S600 DIY FPV Drone 4axis Quadcopter Kit Pix2.4.8 Flight Control GPS 7M 40A ESC 700kv Motor FS-I6 TX RX Lipo Battery Full
S600 DIY FPV Drone 4axis Quadcopter Kit Pix2.4.8 Flight Control GPS 7M 40A ESC 700kv Motor FS-I6 TX RX Lipo Battery Full

S600 DIY FPV Drone 4axis Quadcopter Kit Pix2.4.8 Flight Control GPS 7M 40A ESC 700kv Motor FS-I6 TX RX Lipo Battery Full Item NO.: F19457-E

Write a Review
US$ 225.65
US$ 265.47 Save US$ 39.82 (15% Off)
Sold Out

Copy and share this link on social network or send it to your friends

Copy
Product Name S600 DIY FPV Drone 4axis Quadcopter Kit Pix2.4.8 Flight Control GPS 7M 40A ESC 700kv Motor FS-I6 TX RX Lipo Battery Full
Item NO. F19457-E
Weight 3.3429 kg = 7.3698 lb = 117.9173 oz
Category DIY RC Drone Accessories > ESC
Brand XT-XINTE
Creation Time 2017-07-25

DIY RC Drone Full Kit 4-Axle S600 Frame kit PIX 2.4.8 Flight Control FS-i6 6CH Transmitter ESC Motor GPS with Battery Charger

 

Product Listing :

 

S600 Super Hard Arm 4-Axis Rack Quadcopter Frame Kit with Landing Gear Skid *1

JMT 40A Brushless ESC Speed Controller *4

HYD 3508 700KV 198W Disc Motor *4

Three-hole High Quality Carbon Fiber 15x5.5 1555 Propeller CW CCW Prop * 2pairs

PX4 PIX 2.4.8 32 Bit Flight Controller Integrate PX4FMU PX4IO Safety Switch Buzzer 4G SD*1

UBLOX NEO-7M 7M GPS Module with Compass *1

CNC GPS Anti-interference Antenna Mount Holder Stent Case*1

8 Channel PPM Encoder *1

APM2.6 2.5 2.52 Power Module Current Module APM with 5.3V DC BEC *1

Thick Gold Plated 3.5mm Bullet Connector ( banana plug ) *1

Hook and & Loop Fastening Tape *1

Flysky FS-i6 6CH 2.4G AFHDS 2A LCD Transmitter iA6 Receiver Mode 2/1 Radio System *1

IMAX RC B3 Pro Compact Balance Charger *1

JMT 11.1V 4400MAH 30C 3S1P xt60 Plug *1

Lipo Battery Voltage Tester Volt Meter Indicator Checker Dual Speaker 1S-8S Low Voltage Buzzer Alarm  *1

 

 

 

Frame Kit Specifications:

 
Wheelbase: 600mm
 
Tripod height: 250mm
 
Maximum available paddle: 15 inch
 
Weight:  860g
 
Upper and lower center plate middle height: 36mm
 

 

Pix 2.4.8 Spacifications :

 

 

Note:

Open source products, once sold, no return, if quality problems, Please return for repair . Does not provide one to one support. Buy carefully!

If you are using a PWM receiver, please ready a PWM / PPM converter.

 

 

Description:
- The board integrates with PX4FMU+PX4IO
- Pixhawk is with new 32 bit chip and sensor technology

Features:
- Advanced 32 bit CortexM4 ARM high performance processor, can run RTOS NuttX real time operating system;
- 14* PWM/ actuator output;
- Bus interface (UART, I2C, SPI, CAN);
- Integrated backup power supply and failure backup controller, the main controller can be safely switched to backup control;
- Provide automatic and manual mode;
- Provide redundant power input and fault transfer function;
- Color LED lamp;
- Multi tone buzzer interface;
- Micro SD to record flight data;

Processor:
- 32 bit 2M flash memory STM32F427  Cortex M4, with hardware floating point processing unit
- Main frequency: 256K, 168MHZ RAM
- 32 bit STM32F103 backup co processor

No related record found