S600 DIY FPV Drone 4 axis Quadcopter APM2.8 Flight Control GPS 7M 40A ESC 700kv Motor FS-I6 TX RX 4400MAH Battery Full Item NO.: F19457-J

DIY RC Drone 4 Axle FPV S600 Frame Kit with APM 2.8 No Compass Flysky FS-i6 TX Battery Charger 700KV Motor 40A ESC XT60

Package Listing :

S600 Super Hard Arm 4-Axis Rack Quadcopter Frame Kit with Landing Gear Skid F450 Frame Upgraded*1

JMT 40A Brushless ESC Speed Controller *4

HYD 3508 700KV 198W Disc Motor*4

15x5.5 3K Carbon Fiber Propeller CW CCW 1555 CF Prop*2 Pairs

APM2.8  No  Compass Flight Controller Board Bent Pin with Case *1

 NEO-7M 7M GPS Module with Compass *1

CNC GPS Anti-interference Antenna Mount Holder Stent Case*1

5pcs 10cm Servo Receiver Extension Lead Wire Cable M/M *1

Thick Gold Plated 3.5mm Bullet Connector ( banana plug ) *12

Hook & Loop Fastening Tape *1

Flysky FS-i6 6CH 2.4G AFHDS 2A LCD Transmitter iA6 Receiver *1

IMAX RC B3 Pro Compact Balance Charger *1

JMT 11.1V 4400MAH 30C 3S1P T Plug Battery *1

Frame Specifications:

APM Description :

---- With Protective case but no Shock Absorber! For the detail connection and programming, please contact me directly for that.

Size: 70*45*13.5
Weight: 28G

APM is an open source flight control, can you play APM well depend on individual ability. Player must have ability of basic understanding of monolithic integrated circuit, c-language, knowledge of electrical,mechanical, and also needs a certain degree of mental capacity, financialand material resources, energy support.If you're not ready, then We recommend that you prepare some introductory information first.

Introduction:

Eliminate V2.52  Version Old 1.0mm 6P SM06B GPS interface , changed to the DF13-4P compass external I2C interface, Place the DF13-5P GPS interface with external interfaces of the compass , more convenient to connections GPS with external compass.
Replaced the V2.52 I2C interface to multi-purpose MUX interfaces, which can be used by the users themselves through the Pad of Back Board freely configurable function output, UART0,UART2,I2C,OSD optional, defaults OSD interface, avoiding 2.52 version when you want to use both Data Transmission and OSD, you need to use Y-line separating the interface programme. Improved OSD interface when used in conjunction with Data Transmission, because of the isolation resistance, more effective to avoid the interference of Data Transmission.
New V2.8.0 use United States semi-LP2985-3.3, pressure-resistant up to 16V, increased reliability, reduced probability of Bad Gyro health due to voltage problems.