Home>DIY RC Drone Accessories>Motor>RC HexaCopter ARF Electronic: KK Multicopter V2.3 Hex-Rotor Flight Control Board 30A ESC A2212 1000KV Motor

RC HexaCopter ARF Electronic: KK Multicopter V2.3 Hex-Rotor Flight Control Board 30A ESC A2212 1000KV Motor Item NO.: F05114-D

Name: RC HexaCopter ARF Electronic: KK Multicopter V2.3 Hex-Rotor Flight Control Board 30A ESC A2212 1000KV Motor
Brand: XT-XINTE
SKU: F05114-D
Price: 50.05 USD
Availability: SoldOut

Write a Review

US$ 50.05

US$ 58.89 Save US$ 8.83 (15% Off)

Sold Out

Product Name	RC HexaCopter ARF Electronic: KK Multicopter V2.3 Hex-Rotor Flight Control Board 30A ESC A2212 1000KV Motor
Item NO.	F05114-D
Weight	1.012 kg = 2.2311 lb = 35.6972 oz
Category	DIY RC Drone Accessories > Motor
Brand	XT-XINTE
Creation Time	2017-07-25

RC HexaCopter ARF Electronic: KK Multicopter V2.3 Hex-Rotor Flight Control Board 30A ESC A2212 1000KV Motor

(Please pay attention this:

The Radio Controller Software upgraded,The wire connecting for Receiver and KKMulticopter board has been changed.Please check and like this:)

Description

KKMulticopter V2.3 Circuit board Flight Controller V5.5 Hexa Mode For RC 6-Axis HexaCopter Multi-Copter Aircraft UFO

This is the latest v.5.5 KKmulticontroller that has been factory made and fully populated. It uses the Murata piezoelectric gyros which have been incorporated into the board design for robustness. The Yaw gyro assembly is also slot mounted for extra robustness. These gyros have proven to be the most vibration resistant of all the gyros we have tested so far.

The board comes in black with a blue LED and has an on board In System Programming (ISP) header to enable easy firmware updates with a site recommended programmer. The on board Atmega168 chip gives users the extra space to load expanded firmware with higher refresh rates to enhance stability.

The three adjustable potentiometers increase or decrease gyro gain for all three axis (Roll, Pitch and Yaw) and can be used to calibrate the ESCs and reverse the gyro directions if necessary during pre-flight setup.

The board also has six ESC/Servo headers which allow multicopter configurations from 2 to 6 rotors. There are also headers for thee aileron, elevator, throttle and rudder connections from your RC Receiver(RX). The board comes with a 4 x 3 pin jumper cables to connect your RX to the board quickly and easily.

There's variety of firmware available for this controller, you will have load them due to your needs, only test program is loaded by default.