Qiotek ASP5033 Digital Air Speed Meter Sensor Kit for Pixhawk APM PIX Flight Controller RC Airplane Item NO.: F43811 F43812

Qiotek ASP5033 Digital Air Speed Meter Sensor Kit for Pixhawk APM PIX Flight Controller RC Airplane

The ASP5033 driver has been incorporated into the ardupilot firmware. ASP5033 I2C sensor requires firmware version above arduplane 4.1 and firmware version below arduplane 4.1, Please purchase ASP5033 CAN interface module.

Qiotek does not license other manufacturers to produce the sensor, Please recognize the Qiotek logo & website link when purchasing.

Description:
Brand: Qiotek
Item: Air speed meter
Weight: 0.06oz; 2 g
Type: ASP5033 Air Speed Meter/ ASP5033 Air Speed Meter+Air Speed Tube/ PIX Air Speed Meter/ PIX Air Speed Meter+Air Speed Tube/ 
The differential pressure sensor, digital output using I2C interface, the total error within the compensation range is less than 0.5%. 


Automatic matching dynamic pressure & static pressure, Just the dynamic pressure and static pressure connected to the pitot tube are OK
Adopt GH1.25 terminal interface. The distribution terminal cable can be directly linked directly to the flight control I2C expansion board.

Sensor: Automatic matching dynamic pressure & static pressure
Corresponding to the connection of the airspeed tube
The arrow is installed forward of the aircraft. Connect the pitot tube two holes to the sensor holes. 

Differential Pressure Sensor board
 ASP5033 is a prefect silicon pressure sensor module offering a digital IIC interface for reading differential pressure over the specified full scale pressure span and temp.range. ASP5033 is fully calibrated and temperature compensated for offset, sensitivity, temperature and non-linearity. 


Ranges: -20Pa…～+20kPa
Accuracy: +-0.2% Span
Total error band(TEB):0.5%
Over Pressure: 2X rated
Temp.Accuarcy: +-1℃
Power supply: 4.5-12V 
Current consumption : <8uA(one time measurement)
Static Current: <120nA (25°C)
Operating Temperature:  -40°C~125℃
Temperature Accuracy: +-0.5@25.00℃

Package Included:
1x ASP5033 Air Speed Meter
1x GH1.25 or SH1.25 wire
1x Industrial grade UV curing 3D printing pitot tube.