Home>RC Toy Drone>QWinOut ZD850 DIY Drone Kit with Landing Gear PIX Flight Controller 620KV Motor 40A Brushless ESC Propellers XT60 Plug Power Hub for RC 6-axle Hexacopter UFO Drone
QWinOut ZD850 DIY Drone Kit with Landing Gear PIX Flight Controller 620KV Motor 40A Brushless ESC Propellers XT60 Plug Power Hub for RC 6-axle Hexacopter UFO Drone

QWinOut ZD850 DIY Drone Kit with Landing Gear PIX Flight Controller 620KV Motor 40A Brushless ESC Propellers XT60 Plug Power Hub for RC 6-axle Hexacopter UFO Drone Item NO.: F19833-J F19833-K

Write a Review
US$ 276.43
Sold Out

Copy and share this link on social network or send it to your friends

Copy
Product Name QWinOut ZD850 DIY Drone Kit with Landing Gear PIX Flight Controller 620KV Motor 40A Brushless ESC Propellers XT60 Plug Power Hub for RC 6-axle Hexacopter UFO Drone
Item NO. F19833-J F19833-K
Weight 3.388 kg = 7.4693 lb = 119.5082 oz
Category RC Toy Drone
Brand QWinOut
Creation Time 2020-11-06

QWinOut ZD850 DIY Drone Kit with Landing Gear PIX Flight Controller 620KV Motor 40A Brushless ESC Propellers XT60 Plug Power Hub for RC 6-axle Hexacopter UF0 Drone

Note :  Product is DIY Version, Unassembled Kit and NO Manual, Please take it into account before ordering. Our technicist will help client to weld the some wiring for ESC and we will test all electronic parts before shipment. If any Technical questions, Please message us 


Note: The item do not include Battery! Recommend 3-6S less than 10000mah Lipo battery

 

Combo 1 Product Listing :
ZD850 Full Carbon Fiber Frame Kit with Unflodable Landing Gear Foldable Arm *1
350KV Brushless Motor *6
40A Brushless ESC Speed Controller *6
Power Hub *1
Carbon Fiber 15x5.5 CW CCW Propellers *3 Pairs
1m Black and Red 16AWG Silicon Wire Connecting Wire *3
XT60 Male with 14AWG Wire *1 
4X Hook & Loop Fastening Tape *1

Combo 2 add:

PIXHAWK 2.45 32bit Flight Control Set PIX PXI PX4 Multi-axis Aircraft Fixed-wing Drones APM Upgraded *1

3DR Telemetry Module Replacement APM Pixhawk Wireless wifi Telemetry Data Transmission Support Mobile Phone And Computers *1

RadioLink AT10 II RC Transmitter 2.4G 12CH Remote Control System with R12DS Receiver* 1



Precautions:
1 Do not charge the battery when you are away from home, do not charge the battery immediately after flying, do not over-discharge the battery (over-discharge may cause the battery to fail to charge and become useless). .
2. Do not modify any parameters and wiring without knowing the flight control and remote control.
3. Turn on the remote control before powering on the airplane, unplug the power switch after the flight, and then close the remote control to prevent accidents.
4. This aircraft is recommended to fly indoors. It can fly in an open place outdoors when there is no wind, and avoid flying in crowds and places with disturbing objects around.
5. The product is unassembled/welded in loose parts. If you have any technical and assembly questions, please feel free to contact us. We have a dedicated technical team to answer related questions. If customers need to assemble, please feel free to contact us, we will give a reasonable quotation for additional logistics freight and technical assembly fees.
6. This product is not a toy and is not suitable for children under 14 years of age.
7. Please read the instructions carefully before any use. If you are a beginner, it is recommended to be assisted by an experienced adult
8. Because the airplane is relatively small, don’t fly high and far. 9. Novices should pay attention not to use the airplane when the airplane is turning or let children take it to prevent it from being scratched.
10. Please turn off the start switch in time when the aircraft falls from a wall or hits other objects during flight, otherwise it may cause damage to the flight control motor, etc. Check whether the aircraft is damaged or the screws are loose.


Functions and features:
850mm wheelbase arm foldable frame
Maximum load: 3.5KG under 6S battery
Can be used for aerial photography and aerial survey
With data transmission, it can plan flight routes

Paddle:
Specification: 1555
Material: carbon fiber
Length: 15 inches
Spacing 5.5
Main hole 4mm
Side hole 3mm
Center distance 12mm

ESC:
Current: 40A
Peak current (10 seconds): 60A
BEC: None
Battery LiPo: 2-6S
Programmable elements: synchronization (high/medium)
Weight: 26g
Size: 68 * 25 * 8.7

Motor:
Size: 5010
KV: 350 KV
Shaft diameter: 4 mm
Weight: about 105 grams
Applicable voltage: 2-6S

No related record found