Copy and share this link on social network or send it to your friends
CopyProduct Name | JMT SZ007 2.4G Remote Controller with Receiver Easy Switch between Left Hand Throttle and Right |
Item NO. | F21788 |
Weight | 0.9405 kg = 2.0734 lb = 33.1752 oz |
Category | DIY RC Drone Accessories > Motor |
Tag | |
Brand | JMT |
Creation Time | 2017-08-01 |
Note: The default setting is a right-handed accelerator, if the user intends to switch to the lefthanded one, please switch the mechanical accelerator button before off-on A electronical throttle is switched. And it can be normally used after saving.
Fundamental Parameter
(1) Modulation mode - GFSK 2.4GHz mode - TFHSS random automatic frequency hopping digital system
(2) Applicable in: fixed-wing aircraft, cars, boats, multi-rotor aircraft
(3) Sending power: less than or equal to 100Mw
(4) Send frequency: 2.400MHz ---- 2.485MHz
(5) Control range: about 1000 meters
(6) Power supply requirements for transmitter: 2S-3S lithium battery (7v-12v)
(7) Power supply requirements for receiver: 5V-12V
(8) Low voltage alarm range of the transmitter: 2S battery voltage less than 6.8V; 3S battery 10.2V
(9) Weight: 475 grams (without battery)
Match code receiving method of the remote control
Before the power is on, the match code button of the receiver shall be firstly pressed. At the same time when the power is on, the red light flashes and the receiver enters into the state of code matching, while you shall press down and hold the two fine-tuning keys in the middle of the transmitter and press the power button to boot. The transmitter enters in to the code matching state as the signal light flashes. Pull the accelerator to the lowest, and the light of receiver shows solid red if succeed, and the light of transmitter solid green.
Notes
(1) Ensure that the remote control has sufficient power, when the battery voltage is lower than the alarm voltage, the transmitter will beep continuously like di, di, di, indicating that the remote control shall be charged in a timely manner.
(2) When using remote control equipment of 2.4GHz, please comply with the local regulated range.
(3) The 2.4GHz wireless electricity system manufactured by us company shall be matched with corresponding transmitter and receiver of our company.
(4) Please operate and use the product strictly under the instructions. Do not modify or dismantle or violate the rules, preventing from suffering loss.
Package Include
1x JMT SZ007 7CH Transmitter
1x SZ007 7CH Receiver
1x Manual
SKYPE: +8615012643826
Email:yxy@xt-xinte.com
No related record found