JMT F4 Flight Control with 4pcs Razor32 V2 35A BLheli_32 3-6S ESC XT60 Connector Cable for DIY RC FPV Racing Drone 210-250mm Quadcopter Item NO.: F32802-B

JMT F4 Flight Control with 4pcs Razor32 V2 35A BLheli_32 3-6S ESC XT60 Connector Cable for DIY RC FPV Racing Drone 210-250mm Quadcopter

Package include:
1xF4 Flight Control
4xRazor32 V2 35A BLheli_32 3-6S ESC
1xXT60 Connector Cable
 

New F4 flight control:

 

1. Using OMNIBUSF4 firmware

 

2. Master STM32F405 GRT6 refresh rate up to 8K.

 

3.PCB 3OZ copper thickness to enhance current stability and rapid cooling

 

4.BEC 5V3A output

 

5. Exposed pads for easy soldering and discarding traditional distribution boards.

 

6 compatible with all the ESC market

 

7. Flight Control IMU integrated OSD without brushing independent firmware, support BF ground station reference OSD

 

8. Integrated galvanometer, real-time monitoring current power consumption and other data

 

9. You can use the remote control to adjust the OSD data such as flight control PID

 

10. Open ports can be adjusted from the OSD map, such as power, frequency band, frequency (support for the function of the map such as Black Sheep Legend, and the upcoming DYS map)

 

11.F4 flight control using an independent four damping ball, can filter out the vibration of the motor, so that flight experience better

 

ESC M1-M4: Connect the power cord

 

V + -V-: corresponding to the ESC power line positive and negative, with '-' for the ground.

 

B + - B-: Lithium battery input

 

BOOT: BOOT button (used as brush firmware)

 

+5 V: With 3A output, can be connected to the picture, receiver, camera.

 

GND: Ground

 

Vout: video output, then picture transmission image signal line

 

Vin: video input, then camera signal cable

 

LED: Programmable LED_Strip signal line output

 

RX6 (S): Connect the SBUS receiver here

 

RX1 (D): Connect DSM2 / DSMX / IBUS receiver here

 

PPM: Here PPM receiver

 

VBAT: Wide voltage picture positive power supply (with battery voltage synchronization), where the voltage is the power voltage

 

BUZ +, BUZ-: BB ring at the line (only supports active buzzer, distinguish between positive and negative)

 

RX3, TX3: Serial port URAT3