JMT 220mm DIY FPV Racing Drone Carbon Fiber Quadcopter Set with F3 FC 2300kv Motor 20A ESC 5.8G 40CH OSD VTX 700TVL PAL/NTSC FPV Camera
Version Optional:
PNP: no Battery&Charger, no Remote control&RX PNF(Plug Not Fly): with Battery&Charger, no Remote control&RX ARF(Almost Ready to Fly): with Battery&Charger, with Remote control&RX, Complete set, need to assemble
Wheelbase: 220mm Flight Control: F3 FC Motor: 2300kv 2-3s ESC: 20A 2-4S 5V1A BEC Paddle: 5053 Battery: 3S 11.1V 1500mah 40C XT60 lipo Remote control: FS-i6 Receiver: FS-A8S Camera: COMS 700TVL PAL/NTSC Image transmission: 5.8G 40CH 25/100 / 200MW support OSD RC distance: about 300m Fly time: about 10min (the specific flight time depends on flight actions)
Precautions: 1 Do not charge the battery when you are not at home. Do not charge the battery immediately after flying. Do not over-discharge the battery. 2. Please read the instructions carefully before any use, and do not modify any parameters and wiring. If you are a beginner, it is recommended to be assisted by experienced adults 3. Turn on the remote control before powering the aircraft. After the flight, unplug the power and then turn off the remote control to prevent accidents 4. This aircraft is recommended to fly indoors. If there is no wind, you can fly outdoors in open areas to avoid flying in crowds and surroundings with interference 5. This product is not a toy and is not suitable for children under 14 years 6. Do not fly high because the plane is relatively small 7. Novices should pay attention not to pick up the plane with your hands or let children pick it up to prevent being scratched when the plane is turning 8. Please turn off the start switch in time when the aircraft falls into the wall at high altitude or hits other objects. Check whether the aircraft is damaged, whether the screws are loose, and everything is normal before you can take off again
No related record found