Copy and share this link on social network or send it to your friends
CopyProduct Name | Holybro PM07-12S Power Module 2S-12S With 80mm XT60 Connector Wire For Pixhawk 6C和Pixhawk 4 |
Item NO. | F48711 |
Weight | 0.045 kg = 0.0992 lb = 1.5873 oz |
Category | DIY RC Drone Accessories |
Brand | Holybro |
Creation Time | 2022-10-26 |
Holybro PM07-12S Power Module 2S-12S With 80mm XT60 Connector Wire For Pixhawk 6C和Pixhawk 4
PM07-12S Power Module
Description:
This PM07 Power Module supplies clean 5.2V to flight controller from the battery
and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable,
along with integrated esc power & signal distribution for up to 8 ESCs. It is designed specifically for flight
controller that do not have built-in servo header pins like the Pixhawk 6C & Pixhawk 4. It comes with pre-soldered
wires, capacitor, and XT60 connector.
Specifications:
Input voltage: 2S-12S
PCB Cont. Current Rating: 90A
PCB Burst Current Rating: 140A (<60 Sec)
Output: DC 5.2V & 3A Max
Voltage Divider: 18.182
Amperes per Volt: 36.364
Please Note:
- The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst
current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed
accordingly. You can refer to this chart for reference.
- This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital
PM like PM02D).
Mechanical Specification:
Dimensions:68*50*10 mm
Mounting Holes:45*45mm
Weight: 47.5g
Setup guide for PX4 & Ardupilot can be found in the Holybro Doc here.
PM07 User guide can be found here
Package Include:
1x PM07 board
1x 80mm XT60 connector wire (installed)
1x Electrolytic capacito: 220uF 63V (installed)
2x JST GH 10P Cable
1x JST GH 8P Cable
2x JST GH 6P Cable
SKYPE: +8615012643826
Email:yxy@xt-xinte.com
No related record found