HolyBro Power Management Board PM02D For Pixhawk 4 Pixhawk 5X Pixhawk 6X Flight Controller DIY Parts Item NO.: F48716

HolyBro Power Management Board PM02D For Pixhawk 4 Pixhawk 5X Pixhawk 6X Flight Controller DIY Parts

Product Details:
PM02D provides regulated power supply for your Pixhawk® 5X & 6X from the battery,  as well as current consumption
and battery voltage measurements, all through a 6pin cable. The on-board switching regulator outputs 5.2V and a
maximum of 3A from LiPo batteries up to 6S. The Power Module comes completely assembled with XT60 connectors,
wrapped in shrink tubing for physical damage protection.

It is not designed to power servos, please use your aircraft's ESC/BEC for that. The Molex 2.00mm pitch CLIK-Mate
Wire-to-Board connector is rated for 3.0A current per contact.
Note: PM02D uses I2C digital signal data output and not compatible with Pixhawk 6C, Pixhawk4, Pixhawk4 Mini, pix32
v5, or Durandal flight controllers.


Spec：
Input voltage: 2S - 6S
PCB Cont. Current Rating: 60A
PCB Burst Current Rating: 100A (<60 Sec)
Max current sensing: 164A
Voltage and current monitor with I2C compatible interface
Outputs 5.2V and 3A max
Weight: 20g
PIN MAP:

Package Includes：
1x  PM02D Power Module
1x  6pin 2.00mm pitch cable