Happymodel EX1105 3-4 S 5200KV Engine with Crazybee F4 PRO V3.0 Flysky Flight Control / Frsky RX 3018 3 inch Propeller for DIY FPV Mini Drone Item NO.: F33051-D/F33051-E

Happymodel EX1105 3-4 S 5200KV Engine with Crazybee F4 PRO V3.0 Flysky Flight Control / Frsky RX 3018 3 inch Propeller for DIY FPV Mini Drone


Frames and display items Include:
2 Pcs CW Engine
2 pcS CCW Motor
1 pcs F4 PRO V3.0 Flight Controller
8 Pairs 3018 3 Inch Propeller

Specific:
Brand: Happymodel
Model: EX1105
Item name: 1105 KV5200 3-4 S Brushless Motor
Configuration-ration: 9N12P
Stator Diameter: 11 mm
Stator Length: 5mm
Shaft diameter: Φ1. 5mm
Engine Dimensions (Diam. * Len): Φ14mm * 17mm
Weight: 5.7g
Cable length: 70 mm includes the connector
Plug interface: JST 1.25 mm 3pin
Features:
- New rotor design
- High efficiency and smooth
- Double bearing and more balance
- Better for toothpicks / twig of construction


3018 3x1.8 3 Inch Propeller

Model: Hurricane 3018
Item name: 3018 3x1.8 3 Inch 2-Blade Propeller
Quantity: 4 CW and 4 CCW
Color: Transparent Gray
Weight: 0.75g

Features:
-2mm press fit and T mount
- It fits 1.5mm shafts with T mount
-In polycarbonate
- Very low load

Crazybee F4 PRO V3.0 Flight Control Specification:

(Frsky version) CRAZYBEE F4FR PRO V3.0 Destination firmware: CrazybeeF4FR
(Flysky version) CRAZYBEE F4FS PRO V3.0 Destination firmware: CrazybeeF4FS

MCU: STM32F411CEU6 (100 MHZ, 512 K FLASH)
Sensor: MPU-6000 (SPI connection)
The dimensions of the card: 28.5 * 28.5 MILLIMETERS

Po & power supply: 2-4 S input battery (DC 7-17 V)
Built-in 10A (each) Blheli_S 4in1 ESC Dshot600 ready
Frsky Built-In SPI Frsky telemetry receiver (D8 / D16 switchable)
Flysky Built-In version SPI Flysky telemetry receiver (switchable AFHDS / AFHDS2A)
No RX version you need to add external receiver
Built-in Betaflight OSD (SPI Control)
Built-in Max Current Meter 70A
Current meter scale set to 470
Built-in 5 V 1A BEC
Built-in voltage detection
 
MCU updated to EFM8BB21
Po & power supply: 2-4 S LiPo / LiPo HV (7 v / 17 v)
Current: 10A continuous pe & ak 12A (5 seconds)
BLHeliSuite programmable support
Factory firmware: F_H_40_REV16_5.HEX
Default protocol: DSHOT600
 
BUS SPI receiver
Frsky D8 / D16 switchable
Compatible Non-EU transmitter both D8 and D16 mode
Channels: 8ch or 16ch
Support fail-safe
No interference ground (Transmitter and receiver 1 m from the ground): 300 m
 
BUS SPI receiver
Protocol: AFHDS and AFHDS-2A Switchable
Channels: 8ch (AFHDS) or 14ch (AFHDS-2A)
No interference ground (Transmitter and receiver 1 m from the ground): 300 m
Support fail-safe
 
No RX version external serial-bus support receiver such as XM +, crossfire, S-FHSS etc.