Home>DIY RC Drone Accessories>Motor>Happymodel EP40 Plant Protection UAV Large Flow Electric Medicine Pump Water Pump Brushless Gear
Happymodel EP40 Plant Protection UAV Large Flow Electric Medicine Pump Water Pump Brushless Gear

Happymodel EP40 Plant Protection UAV Large Flow Electric Medicine Pump Water Pump Brushless Gear Item NO.: F26552

Write a Review
US$ 16.61
US$ 19.54 Save US$ 2.93 (15% Off)
Sold Out

Copy and share this link on social network or send it to your friends

Copy
  • Happymodel EP40 Plant Protection UAV Large Flow Electric Medicine Pump Water Pump Brushless Gear
Product Name Happymodel EP40 Plant Protection UAV Large Flow Electric Medicine Pump Water Pump Brushless Gear
Item NO. F26552
Weight 0.15 kg = 0.3307 lb = 5.2911 oz
Category DIY RC Drone Accessories > Motor
Brand Happymodel
Creation Time 2018-11-06

Happymodel EP40 Plant Protection UAV Large Flow Electric Medicine Pump Water Pump Brushless Gear

Plant protection machine pump
 The plant protection machine uses a brushless gear pump, which is only 123 grams light, with a large pump pressure and a design working life of 200 hours. Pump and flow changes are small throughout the life cycle, and maintenance and spare parts replacement costs are low. Suitable for plant protection drones of various specifications.
 When using 12V and 25V for endurance test, the parameters we measured were: 1A for no-load, 3.4L for 12V2A, and 4.7L for 25V2A, and the change of water output after 200 hours. More than 10%.
 Installation and use precautions:
  1: The gear pump should be installed below the liquid level.
  2: This gear pump can be powered by 3S, 6S battery.
  3: The gear pump can change the flow rate after adjusting the electric speed.
  4: Install a filter at the water inlet or make sure that the liquid is free of impurities to avoid damage to the pump.
  5: Please clean the medicine box and the medicine pump with water before using it for a long time or before storing it to avoid the condensation of the medicine and damage the medicine pump.
  6: Cleaning of the medicine box and the medicine pump: fill the medicine tank with clean water, start the medicine pump, and pump out.
  7: The gear pump is strictly prohibited from idling. When there is no liquid cooling and lubrication during idling, it is easy to cause high temperature damage to the pump body.
 The setting of the medicine pump before use:
  Use a toggle switch on the remote control to control the ESC's ESC. First select the corresponding switch channel and plug in the ESC control line. After the ESC and receiver are powered, listen to the ESC apocalypse. Confirm that the ESC is high and set the calibration sound to swing the switch to the opposite position. Wait for the ESC calibration to complete. The approach is the same as the throttle channel travel. After the setting is completed, the toggle switch is used to test the drug pump. If the flow rate of the pump is too large, the highest point stroke of this channel is set in the remote controller, and the maximum stroke parameter of the switch is lowered, and the flow rate of the pump is lowered. Save the remote control settings after the test is over. Disconnect the ESC and the receiver power supply. Make sure that the remote control pump switch is at the lowest position before each use. The aircraft can be sprayed normally after the switch is turned on.
 Drug pump repair
  The running part of the pump body is the plastic part molded by the mold. Therefore, the replacement cost is very low. If the user feels that the self-maintenance can be repaired, the pump can be sent back to the repair and replacement operation part, and the cost will not exceed 20 yuan (the freight is extra). It is a waterproof motor compartment made of aluminum alloy CNC. The motor and aluminum alloy parts will not be damaged when used normally.

No related record found