Copy and share this link on social network or send it to your friends
Copy| Product Name | Happymodel Crazybee F4 Pro Flight Controller SE0803 0803 1-3S CW CCW Motors Combo for Bwhoop75 Brushless Whoop Mobula7 Eachine TRASHCAN TC75 |
| Item NO. | F4 FC Motor Combo |
| Weight | 0.04 kg = 0.0882 lb = 1.4110 oz |
| Category | DIY RC Drone Accessories > Motor |
| Brand | Happymodel |
| Creation Time | 2019-02-19 |
Happymodel Crazybee F4 Pro Flight Controller SE0803 0803 1-3S CW CCW Motors Combo for Bwhoop75 Brushless Whoop Mobula7 Eachine TRASHCAN TC75
Package include:
1x Crazybee F4 Pro Flight Controller
2xSE0803 1-3S CW Motors
2xSE0802 1-3S CCW Motors
The motor with red Cable= clockwise CW
The motor with black Cable = counter-clockwise CCW
Item name: SE0803 1-3S brushless motor
KV options: 12000KV(2s-3s) 16000KV(1s-2s), 19000KV (1s)
Shaft Diameter: 1.0mm
Configuration: 9N12P
Stator Diameter: 8mm
Stator Length: 3mm
Motor Dimension(Dia.*Len): dia 10.5mm*16mm
Terminals: JST1.25mm
No.of Cells(Lipo): 1-3S
Wire length(include connector): 40mm
Weight: 2.5g
Features:
Super tiny only 2.5g
Compatible for 1s-3s brushless whoop
Ball bearing and Bushing
Double E-clip design, prevent Motor bell to flying off
Good Dynamic balance
Pacakge included:
2PCS Motors CW (Red Cable)
2PCS Motors CCW(Black Cable)
Happymodel Crazybee F4 PRO Flight Controller 1-2S Compatible Flysky/Frsky/DSMX Receiver for 2S Brushless Tiny Whoop For Mobula7 Mobula 7 Upgrade Eachine TRASHCAN TC75
|
Flight controller |
CRAZYBEE F4 PRO Firmware target: CrazybeeF4DX MCU:STM32F411CEU6 (100MHZ, 512K FLASH) Sensor: MPU-6000(SPI connection) Board size: 28.5 * 28.5MM Power supply: 1-2S battery input (DC 3.5-8.7V) Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready ESC MCU Upgraded to EFM8BB21 Built-in Betaflight OSD (SPI Control) Built-in Current meter sensor Max up to 28A Current meter scale set to 1175 Built-in 5V 1A Buck / Boost with LC filter Built-in voltage detection BLHELI_S pass-through Ready Multi Serial port support Fully compatible with almost Brushless whoop drone Weight:4.2g |
|
Onboard 4in1 ESC |
MCU upgraded to EFM8BB21
Power supply: 1-2S LiPo/LiPo HV (3.5v/8.7v) |
|
Receiver support |
No RX version : support external serial-bus receiver like xm+, crossfire, S-FHSS and Dsm2/DSMX, Ibus protocol etc.
Built-in DSM2/DSMX receiver Version:
Serial bus receiver
Protocol: DSM2/DSMX compatible
Channels:6-9 (Depend on your radio) No ground interference ( Transmitter and receiver 1 m from the ground): 300m
Built-in Frsky NON-EU receiver Version:
SPI BUS receiver
Frsky D8/D16 switchable
Compatible Non EU transmitter both D8 and D16 mode
Channels: 8ch or 16ch
Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground): 300m Built-in Flysky receiver Version:
SPI BUS receiver
Protocol: AFHDS and AFHDS-2A Switchable
Channels: 8ch(AFHDS) or 14ch(AFHDS-2A)
No ground interference ( Transmitter and receiver 1 m from the ground): 300m Failsafe support |
SKYPE: +8615012643826
Email:yxy@xt-xinte.com
No related record found