GEELANG LIGO78X 5A Blheli_S 4 in 1 ESC Dshot600 Betaflight OSD Cinewhoop FPV Racing Drone With 360go Thumb Camera Mounts

Copy and share this link on social network or send it to your friends

Copy

GEELANG LIGO78X 5A Blheli_S 4 in 1 ESC Dshot600 Betaflight OSD Cinewhoop FPV Racing Drone With 360go Thumb Camera Mounts Item NO.: F42093 F42094 F42095 F42096

Write a Review
US$ 102.41 (12% Off)
US$ 116.38 Save US$ 13.97
Receiver:
FRSKY D8 R1mini RX DSMX RX TBS NANO RX PNP NO RX
Quantity:
Shipping Cost:
Estimate Shipping Cost

Product Name GEELANG LIGO78X 5A Blheli_S 4 in 1 ESC Dshot600 Betaflight OSD Cinewhoop FPV Racing Drone With 360go Thumb Camera Mounts
Item NO. F42093 F42094 F42095 F42096
Weight 0.395 kg = 0.8708 lb = 13.9332 oz
Category RC Toy Drone > Hot sale brand
Brand GreenL
Creation Time 2020-11-09

GEELANG LIGO78X 5A Blheli_S 4 in 1 ESC Dshot600 Betaflight OSD Cinewhoop FPV Racing Drone With 360go Thumb Camera Mounts


Features:
*Use SH-50A flight controller to support 2-3s lithium battery power supply. The integrated Betaflight OSD function keeps track of the signal of the flight voltage receiver and can observe the status in real time during flight.
*VTX comes with Smartaudio function, you can adjust the flight control parameters through the OSD, adjust the flight control PID, and adjust the VTX frequency point parameters Completely assembled and debugged, you can fly with the remote control.
*A more compact design is adopted for the first time, with a wheelbase of 78mm. However, passing long-term flight tests will not affect flight efficiency at all. Indoor flight has better maneuverability and playability.The FPV end adopts GL950 camera, the image quality is clear. The complex environment of flying indoors has better observation and controllability.
*The 3s power supply and the 2-inch three-blade propeller have been tested and matched for a long time, and have obtained good operability and durability. It is recommended to use 3s 450mah battery, if you need longer space, you can add 3s 550mah battery. Through continuous improvement, the problem of low efficiency of the 2-inch air duct machine was finally solved. Indoor small cross aerial photography becomes a reality. In order to better protect the outer ring,EVA sponge material is used to improve safety and reduce wind resistance. Through optimization, the performance is very good.
*The flight controller supports Betaflight adjustment, a variety of flight modes, carefully adjusted by the original factory, suitable for novice flight practice, stable style.
*Independent use of multiple versions of the receiver, electronic control is more stable. The flight control adopts the newer version of Betaflight 4.2, and the ESC adopts the 16.77 version. Both the two-way DSHOT mode and the gyroscope RPM filter are turned on to make the flight control more stable.
*The weight of the whole machine is controlled at 72g, which solves the weight problem of the traditional air duct machine and is flexible in control.
*The original factory is equipped with two sets of 360go thumb camera mounts, which can be replaced as needed.
*The tail RGB LED flight control can be adjusted freely.

Spare parts specifications:
Motor
Motor Mode:GL1202 KV8700
Stator specifications:D12 * H4 0.2mm Kawasaki
Configu-ration:9N12P
Stator Diamter:12mm
Stator Length:2mm
Shaft Diameter:Φ1.5mm
WindingSpecifications:180℃ Class Multiple oxygen-free copper
Weight(g):3.4g
No.of Cells(Lipo):2S-3S

Flight controller
Name: SH50AF4 MATEKF411
MCU: STM32F411CEU6 (100MHZ, 512K flash memory)
Sensor: MPU-6000 (SPI connection)
Shop: 8MB black box onboard
Board size: 28.5 * 28.5MM
Power supply: 2-3S battery input (DC 7-12.6V)
Built-in 5A (each) Blheli_S 4 in 1 ESC Dshot600 ready
Built-in Betaflight OSD (SPI control)
Built-in 5V 2A BEC
Built-in voltage detection

Onboard 4in1 ESC
Onboard 4in1 ESC MCU upgraded to EFM8BB21
Power supply: 1-2S LiPo/LiPo HV (3.5v/8.7v)
Current: 5A continuous peak 7A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: S_H_50_REV16_77.HEX
Default protocol: DSHOT300
Power input: XT30

Frsky XM+ Non-EU Receiver Version
SBUS receiver
Frsky D8/D16 switchable
Compatible Non EU transmitter both D8 and D16 mode
Channels: 8ch or 16ch
Failsafe support
No ground interference ( Transmitter and receiver 1 m from the ground): 300m
Operating Voltage Range: 3.7~10V
Operating Current: 30mA @5V
Operating Range: Full range
With RSSI output on board: Analog 0~3.3V
Firmware upgrade-able, can be upgrade to EU with RSSI

Frsky AC900 Receiver Version
Three-in-one receiver
SBUS receiver
Frsky D16 futaba s-fhss switchable
Compatible Non EU transmitter both D16 mode
Channels: 8ch or 16ch
Failsafe support
No ground interference (Transmitter and receiver 1 m from the ground): 300m

TBS NANO Receiver Version
CRSF Protocol,Official TBS transmitter compatible  
Protocol: CRSF  
Channels: 8ch Failsafe support   
Support receiver hardware rssi function

No ground interference: 500m

PNP Receiver Version
Support any bus and other protocols, users can install by themselves

5.8G VTX
Power switching: third gear(25MW /100MW /200MW)
Frequency: 40CH
Input voltage: 3.3V 5.5V
Current consumption: 300mA(type)
Frequency: 5.8GHz 5bands 40 channels
With Raceband
Smartaudio ready(Frsky EU-LBT and DSMX version not compatible) 
Weight: 2.0g

Camera
GL950PRO:1/4 COMS sensor
Horizontal:800TVL 800x600
TV system: ntsc 4:3 non-changeable
Power Input: DC 5-12V
FOV: F1.2
Colorful: 0.1Lux (F1.2, 50IRE, AGC ON)
Black and white: 0.01Lux(F1.2,50IRE,AGC ON) Lens:m7
Signal to noise ratio:> 50dB Dynamic Range:>60dB
White balance: Auto white balance
Image:color
BLC:stand by
Video format:NTSC
Weight: 1.5g

Propeller
Gemfan 2023-3 Toothpick Props
Material: PC
Weight: 0.88g
Pitch:2.3in
Props Dia: 52.17mm
Center Thickness: 5mm
Center Hole Dia:1.5mm 3 holes

Battery Recommended
Species : lipo/lipoHV
Capacity:450-550mah
Voltage:7.8-11.1v
Continuous Discharge Rate: 60C
Instantaneous discharge rate: 80C
Connector: xt30

Package Included:
1*78mm 3D printing combined diy frame
1*3D printed 360go thumb camera bracket
Option1: SH50a FC external Frsky EU/xm+ receiver
Option2: SH50a FC external Frsky\FUTABA AC900 receiver(Multi-mode receiver)
Option3: SH50a FC external TBS NANO receiver
Option4: SH50a FC PNP NO RX receiver
4*GL1202 KV8700 Motor
1*2023 propeller(4cw+4ccw)
1*5.8G VTX5840
1*RGB LED
1*GL950 camera
1*Screwdriver removal tool
1*Battery magic strap
1*High-end paper box
1*Usb cable
1*3s 450mah lihv Battery



No related record found

You May Also Like