Home>DIY RC Drone Accessories>Receiver>FEICHAO RM601X 7Channel 2.4GHz Mini DSM2 DSMX Satellite Receiver for FPV Aircraft/Helicopter/JR and SPECTRUM Remote Control
FEICHAO RM601X  7Channel 2.4GHz Mini DSM2 DSMX Satellite Receiver for FPV Aircraft/Helicopter/JR and SPECTRUM Remote Control

FEICHAO RM601X 7Channel 2.4GHz Mini DSM2 DSMX Satellite Receiver for FPV Aircraft/Helicopter/JR and SPECTRUM Remote Control Item NO.: F39466

Write a Review
US$ 6.46
US$ 7.60 Save US$ 1.14 (15% Off)
Sold Out

Copy and share this link on social network or send it to your friends

Copy
Product Name FEICHAO RM601X 7Channel 2.4GHz Mini DSM2 DSMX Satellite Receiver for FPV Aircraft/Helicopter/JR and SPECTRUM Remote Control
Item NO. F39466
Weight 0.05 kg = 0.1102 lb = 1.7637 oz
Category DIY RC Drone Accessories > Receiver
Brand Feichao
Creation Time 2020-06-20

FEICHAO RM601X 7 Channel 2.4GHz Mini DSM2 DSMX Satellite Receiver for FPV Aircraft/Helicopter/JR and SPECTRUM Remote Control


Specifications:
Name:RM601X
Channel: 7 Channel output
Modulation: DSM2/DSMX
Band:  2.4GHz
Dimensions (W x Lx H):21.5*15mm
Weight: 0.9g
Voltage Range:3.3V
Antenna Length Main RX:13.5cm(2)
Remote ControlRange:500M(tested with JR DSX9)

Features:
Park-zone receiver
ServoSync (feature does not work with module systems)
Preset failsafe system
QuickConnect
Compatibility (Spectrum and JR DSM2/DSMX): DX6I,DX7,DX8,DSX7,DSX9DSX11

Binding Procedure
I. Pressthe bindingbuttonandconnectpower to receiver.Transmitter in Bind model. LED quick flash , binding completed LED will off. Reconnect power to receiver LED keep lit, now receiver is ready to fly.
II.To set fail-safe throttle and control surface positions, (minimum throttle and all control surfaces set to neutral is suggested).Press and hold the bind button of transmitter (LED will illuminate), Turn on the transmitter. 
III. Receiver LED will change from rapid flashing to slow flashing and a few seconds later when bind is accomplished the LED of receiver will illuminate solid.Failsafeshould be programmed correctly .
IV.Restart the receiver by cycling it power off and turn onand connect battery into BIND channel is recommended. All channels should function properly now.  You may test fail-safe by holdingsticks in corner, cycle transmitter on and off.  Surfaces and throttle should return to your preset fail-safe positions.
Notes:Only onetimebind procedure is required on a new receiver.  Repetitive binding provides no extra security.  Always remember to remove the binding harness after successful bind is completed.

Package including:
1xReceiver



No related record found