FEICHAO H467 467mm DIY FPV Racing Drone Kit Quadcopter APM2.8/PIX Flight Controller 40A ESC 1255 Propellers Flysky/Radioking TX18S Controller Item NO.: F42572-B F42572-C F42572-D E F G H I J K

FEICHAO H467 467mm DIY FPV Racing Drone Kit Quadcopter APM2.8/PIX Flight Controller 40A ESC 1255 Propellers Flysky/Radioking TX18S Controller

Note: Please select the version of the corresponding picture.

Functions and features:
1.467mm wheelbase H-shaped body, 16mm diameter carbon tube;
2.The battery life is about 12 minutes. If you want a longer battery life, you can replace the battery with a larger capacity;
3.The maximum load is 1KG under 3S battery;
4.Support voltage 2-4S.
Paddle
Specification: 1255
Material: carbon fiber
Main hole diameter 4mm
Side hole diameter 3mm
Center distance 12mm
ESC
Current: 40A
Output capacity: continuous current 40A, short-term current 55A (not less than 10 seconds)
Power input: 2-4 lithium batteries
BEC output: 5V @ 3A (linear) regulator mode-linear mode)
Maximum speed: 2-pole motor 210,000 rpm, 6-pole motor 7000 rpm, 12-pole motor 35,000 rpm
Size: (approximately) 68x25x8mm"
Motor
KV: 720KV
Stator diameter: 41mm
Stator length: 8mm
Shaft diameter: 4.0mm
Propeller mounting hole diameter: 3mm
Propeller installation distance: 12mm
Motor mounting hole diameter: 2.5mm
Motor installation: 32mm equilateral triangle, 19/25mm straight line
Motor size (diameter * lens): D46x25mm
Weight (g): 113g
Number of batteries (Lipo): 3-6S
Maximum continuous current (A): 30A
Maximum continuous power (W): 666W
Internal resistance: 0.055
Flight control type (optional): APM2.8 or PIX
Q&A

Please refer to our pictures to choose the desired combination. All parts are sold separately in our shop, and you can add them as spares. If you have any questions, please feel free to contact us.
Precautions:
1 Do not charge the battery when you are away from home, do not charge the battery immediately after flying, and do not over-discharge the battery (over-discharge may cause the battery to fail to charge and become useless).
2. Do not modify any parameters and wiring without knowing the flight control and remote control.
3. Turn on the remote control before powering on the airplane, unplug the power switch after the flight, and then close the remote control to prevent accidents.
4. The product is unassembled/welded in loose parts. If you have any technical and assembly questions, please feel free to contact us. We have a dedicated technical team to reply to related questions. If customers need to assemble, please feel free to contact us, we will give a reasonable quotation for additional logistics freight and technical assembly fees.
5. This product is not a toy and is not suitable for children under 14 years of age.
6. If you are a beginner, it is recommended to be assisted by an experienced adult
7. Novices should pay attention not to take the airplane by hand or let children take it to prevent it from being scratched.
8. Please turn off the start switch in time when the airplane falls from a wall or hits other objects during flight. Otherwise, it may cause damage to the flight control motor. Check whether the airplane is damaged or the screws are loose.

Package included(The verison of APM/PIX +3S Battery+T18S Controller):

2x 3K Sarbon Fiber Tube 16*14*373mm
2x 3K Carbon Fiber Tube 16*14*300mm
1x 3D Printed Carbon Tube Connector
1x 3D Printed Flight Control Fastener
8x Aluminum Tube Clamp
2x Motor Mounts
1x ESC Distributor Board
1x XT60 cable
1x Tie
4x Foot Pad
1x 3D Printed Isolation Board 
1x Frame Screw Accessory Kit
4x Propellers(2pcs CW+ 2pcs CCW )
4x 4108 720KV 3-6S Motors
4x 40A ESC 
1x APM2.8 or PIX Flight Control(optional)
1x Receiver
1x GPS Module
1x Flysky/Radioking TX18S Controller(optional)
1x R8 Receiver 
1x 11.1V 4400MAH 30C 3S1P xt60 plug Battery
1x IMAXRC B3 Pro Charger US/EU Plug (Optional)