2.4G SP09X Micro DSM2 DSMX Satellite Receiver for RC MINI FPV Drone Quadcopter Brushless Racer Item NO.: F20579

2.4G SP09X Micro DSM2 Satellite Receiver for RC airplanes

Specification:

-Item Name: 2.4G SP09X micro DSM2 Satellite receiver 
-Frequency range: 2.403-2.479Ghz
-Input power: 5V
-Response time: 22ms / 11ms
-Resolution: 1024/2048
-Display method: LED
-Operating voltage: 3.3V
-Working current: 60MA
-Size: 18mm*13mm*5mm
-Weight: 0.9 g
-Antenna length: 30mm 
-Data format: Serial port
-Protocol: DSM2
-Distance: no ground interference (1 m from the ground ) > 200m
-Uses: Micro indoor/outdoor small aircraft./multi rotor
-Compatible Transmitters: DSM2 / DSMX series of remote control
Pin-out Diagram:

Bind procedure With F3 flight controller:
-Connect Flight controller to computer and open Cleanflight configurator From CLI tab type: "set spektrum_sat_bind = 9" for DSMX or "set spektrum_sat_bind = 5" for DSM2
-Type "save" and after Flight controller reboot remove USB cable (=Power off the board)
-Wait a second and reconnect the USB cable. After cold start satellite led(Orange color LED) should start blinking and transmitter should be turned on while pressing the bind button
-After binding satellite led should be solid. Connect Betaflight and use receiver tab to test that satellite is working correctly.
-Final step is to go to CLI tab and type "set spektrum_sat_bind = 0" and then type "save". This must be done so that satellite doesn't go back to binding mode when the Flight controller is repowered again.