Copy and share this link on social network or send it to your friends
CopyProduct Name | (Holybro)PM06 V2-10S Power Module 2S-10S With 80mm XT60 Connector Wire And JST GH 6pin Cable |
Item NO. | F48713 |
Weight | 0.015 kg = 0.0331 lb = 0.5291 oz |
Category | DIY RC Drone Accessories |
Brand | Holybro |
Creation Time | 2022-10-26 |
(Holybro)PM06 V2-10S Power Module 2S-10S With 80mm XT60 Connector Wire And JST GH 6pin Cable
PM06 V2-10S Power Module
Description:
This PM06 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption
and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated power
distribution for 4 ESCs. It comes with pre-soldered wires, capacitor, and XT60 connector.
Specifications:
Input voltage: 2S-10S
PCB Cont. Current Rating: 70A
PCB Burst Current Rating: 120A (<60 Sec)
Output: DC 5.2V & 3A Max
Ouput Max Power : 18W
Voltage Divider: 18.182
Amperes per Volt: 36.364
Please Note:
- The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst
current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly.
You can refer to this chart for reference.
- This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital
PM like PM02D).
Mechanical Specification:
Dimensions: 35x35x5mm
Mounting hole: 30.5mm*30.5mm
Weight: 24g
Pin Map:
Package Include:
1x PM06 board
1x 80mm XT60 connector wire (pre-soldered)
1x Electrolytic capacito: 220uF 63V (pre-soldered)
1x JST GH 6pin cable
SKYPE: +8615012643826
Email:yxy@xt-xinte.com
No related record found